Firmware changelog of ADM700/ADM710/ADM700 3G tracking devices: 0x47 - 15.05.2018 1. Added: time obtaining through GPRS. Creation of tracking records as well as their uploading could be conducted without GPS/GNSS satellites signal. 2. Revised: optimization of cellular network registration and server connection mechanisms. 3. Revised: the accuracy of the transmitted value from 1-wire temperature sensors is increased to hundredths of degrees. 4. Revised: stability of pictures data transmission is improved. 5. Revised: stability of data transmitting of EUROSENSE fuel sensor parameters is increased. 0x46 - 06.03.2018 1. Added: the possibility of unique identificator of ADM21-tag to be sent to a server. 2. Revised: general device working state stability is increased. 3. Revised: track quality is increased, chances of aberration appearing are decreased. 4. Revised: in case of a damaged picture is sent to the server, installed camera conduct photo process again. 5. Fixed: random value could be sent in CS bit of SR_POS_DATA data packet. 0x45 - 15.12.2017 1. Fixed: pictures, made by a camera, could not be sent in the server. 2. Fixed: SMS generation and sending did not happen, as an event is detected within analog input. 0x44 - 30.10.2017 1. Revised: SIM68E GPS/GNSS module configuration is changed because of the launching of QZSS. 0x43 - 10.07.2017 1. Added: GSM-signal level is presented in percents. 2. Revised: stability of working state of data packets receiving confirmation mechanism is increased. 0x42 - 30.11.2016 1. Revised: device settings changes, made in the ADM Configurator can be recorded faster. 2. Fixed: device could independently reboot itself in case of big amount of records appears in Black Box. 0x41 - 01.09.2016 1. Added: data transmission of CAN-LOG parameters can be monitored via ADM Configurator v 2.1. 2. Added: status of discrete output can be changed, when RFID-card is found by ADM20. 3. Revised: tracker working state stability with RFID-reader ADM20 is enhanced. 4. Revised: working state stability with CAN-LOG is increased. 5. Fixed: stability of simultaneous work of CAN-LOG и Autotracker fuel sensor is improved. 6. Fixed: device periodically lose information about satellites, involved in a navigational objective. 7. Fixed: course value was not transmitted correctly within EGTS. 0x40 - 12.08.2016 1. Revised: quality of server data transmission of EUROSENS DELTA RS fuel sensor values is increased. 2. Revised: tracker working state stability with RFID-reader ADM20 is enhanced. 0x3F - 28.04.2016 1. Added: EUROSENSE DELTA RS fuel level sensor is supported by the means of RS-485 interface. 0x3E - 27.04.2016 1. Revised: tracker working state with conducted ADM20 reader connection is enhanced. 2. Revised: camera working state by the means of RS-232 is improved. 3. Fixed: tracker outputs worked incorrectly in some regimes.